3.0
Villages and territory
Nocatee and the surrounding St. Johns County area, within roughly 40 miles.
Published entries
| No. | Place | ZIP | Scope |
|---|---|---|---|
| 3.01 | Twenty Mile | 32081 | Nocatee village |
| 3.02 | Coastal Oaks | 32081 | Nocatee village |
| 3.03 | Del Webb Nocatee | 32081 | Nocatee village |
| 3.04 | Greenleaf Village | 32081 | Nocatee village |
| 3.05 | Seabrook Village | 32081 | Nocatee village |
| 3.06 | Crosswater | 32081 | Nocatee village |
| 3.07 | Lakeside | 32081 | Nocatee village |
Nocatee villages
- 3.2.01 Coastal Oaks
- 3.2.02 Twenty Mile
- 3.2.03 Del Webb Nocatee
- 3.2.04 Greenleaf Village
- 3.2.05 Seabrook Village
- 3.2.06 Crosswater
- 3.2.07 Lakeside
How a visit is planned
Most of what decides whether a repair finishes on the first visit is settled before the van leaves. Built-in cooking equipment is heavy, it is fitted into an opening cut to the appliance rather than to a standard, and getting it far enough forward to reach the back of it is often the longest part of the job. A wall oven comes out of a column on its own rails and needs two people and a clear route. A rangetop lifts out of a cut-out from above, but only once the counter around it is protected and the gas connection is safe to break.
So the details worth telling us when you book are practical ones: whether the appliance is free-standing or built in, whether the community is gated and how you want the entry handled, whether a van can stand near the door or the carry is a long one, and whether the kitchen is up a flight of stairs. None of that changes the price. It changes whether the part goes in on the day it arrives.
The village entries below record what is specific to each place — how the houses were built, what the kitchens usually contain, and which faults we are actually called out for there.
What does a visit cost anywhere in Nocatee?
$80 flat to come out and find the fault, credited in full against the repair when you approve it. Beyond that, the work below is what these jobs run to once parts and labour are counted — $80 at the low end, $690 at the top of the widest band on this page.
| No. | Work | Completed, parts and labour |
|---|---|---|
| 3.4.01 | Flat diagnostic fee | $80 |
| 3.4.02 | Igniter or spark module replacement | $190–$550 |
| 3.4.03 | Burner valve or orifice service | $230–$660 |
| 3.4.04 | Oven thermostat or temperature sensor | $180–$520 |
| 3.4.05 | Convection fan or motor | $260–$690 |
A range, because the firm figure is written down after the diagnosis and not before it. The band a job lands in depends on which part failed, whether the appliance has to come out of the cabinetry to reach it, and what the part costs the week it is ordered. A written estimate is provided before any repair begins. No work starts without your approval.
Questions about the territory
- Does it cost more to come to one village than another?
- No. The fee is the same everywhere we go: $80 flat across Nocatee and St. Johns County. What changes between villages is access and planning — gates, driveways, and whether an appliance can be drawn clear of its cabinetry — never the figure on the invoice.
- What if my street is not one of the published entries?
- The entries cover the villages we are called to most, but the territory is Nocatee and the wider St. Johns County within 40 miles. If the address is inside that and the appliance is Wolf cooking equipment, we come out to it.